Setting The Current Time; Audio Settings, Adjusting The Tone - Multilaser Silver Manual Del Usuario

pressing the MUTE button. Pressing the button again returns to the original volume.

3.5 Setting the current time

When the player is turned on, the current time will be shown on the display by press CLK briefly.
Press and hold CLK button for 2 seconds to start setting the current time. Press CLK repeatedly
to switch setting item.The hour will start flashing, and you can change the value with the
buttons. If you press CLK again you can set the value for minutes in a similar way; After setting
finished, press and hold CLK for 2 seconds to save it and leaves this menu.
• T he clock works in 24-hour cycles.
• I f you do not press any button for 5 seconds, the display reverts to the original mode.

3.6 Audio Settings, Adjusting the tone

Press the SEL button repeatedly to select the setting you wish to adjust: ...BAS / TRE / BAL / FAD
/ EQ/VOL
You can adjust the setting by turning the knob.
• If you make no change for 3 seconds, the player automatically reverts to the previous function.
• By default the knob adjusts the volume
BASS
TREBLE
BALANCE
FADER
EQ
VOLUME
• 0 0: no adjustment
• - 01...-07: lower setting
3. Basic operation
Adjust bass tone(-7....00...+7)
Adjust treble tone(-7....00...+7)
Adjust left/right balance(L07...01/00/R01...07)
Adjust front rear balance(R07...01/00/F01...07)
Adjust EQ OFF/EQ1/EQ2/EQ3
Volume control(00-40)
25