Using The Fm Receiver; Automatic Tuuning And Storage; Selecting A Stored Frequency; Manual Tuning, Storing Frequencies - Multilaser Silver Manual Del Usuario

Tabla de contenido

Idiomas disponibles

4. Using the FM Receiver

When you turn on the player, the FM receiver will come on if it was the last selected signal source,

or if you have removed the last used USB stick or SD card.

If needed, use the MODE button to select the FM receiver function.

To start a scan and store the currently available FM stations, press and hold the APS button for 2

seconds. You can follow the scanning and memorizing process on the display.

If there are enough channels available, the player will move on to FM2 and FM3 after filling in the

six slots of first band FM1.

• K eep in mind that the receiver may skip weaker stations, and you cannot influence the order in

which the stations are stored.

• I f you wish to store a station in a particular slot, you need to manually tune in to its frequency

and store it.

• I f you are using the receiver at a distant place from the location where you originally stored a

station (e.g., when you are traveling), you may need to find the same station again at a different

frequency. The same stations often air at different frequencies in different geographical locations!

Press and hold the button corresponding to the station's slot (1...6) briefly.Make sure to select the

right band (FM1/FM2/FM3) first by pressing BAND.

• •If you press and hold the channel's button for more than 2 seconds, the player will not go to the

stored frequency, but store the current frequency in the slot instead. This overwrites the previously

stored frequency.

Press the

and

button briefly to manually tune in to the desired station, or press and

hold the

and

buttons to scan automatically for the stronger stations. The scan stops

Tabla de Contenido

Tabla de contenido