Description; Technical Data; Anchor Products / Suitable Tools - Hilti SI 100 Manual De Instrucciones

Description

The SI100 impact screwdriver is an electric tool.
Recommended screwdriver usage:
– Driving Hilti screw anchors of the HUS-H
larger into concrete of C20 to C50 grade and removing
them in accordance with the manufacturer's recom-
mendations. The HUS 7.5 size may not be screwed
in.
– Driving screws into Hilti HRD framing anchors in
accordance with the manufacturer's recommendations.
Extension Cords. Make sure your extension cord is in
good condition. When using an extension cord, be
sure to use one heavy enough to carry the current your
product will draw. An undersized cord will cause a

Technical data

Rated voltage:
Rated current:
Mains frequency:
No-load speed:
Impact speed:
Clockwise / counter-clockwise rotation:
Chuck:
Screwdriver weight without supply cord:
Max. tightening torque:
Double insulation, class II
Right of technical modifications reserved
Anchor products / suitable setting tools
Setting tools
Socket wrench insert S-NSD
Socket wrench insert S-NSD
Socket wrench insert S-NSD
Socket wrench insert S-NSD
Socket wrench insert S-NSD 13
Socket wrench insert S-NSD 17
×
Bit holder S-BHU 50 1 / 1 /
2
Bit S-B-TX 40T
Bit S-B-TX 40
Bit S-B-TX 50
×
Extensions S-V125 1 / 1 /
2 2
Anchor products other than the above-mentioned may not be driven in with or tightened by the SI 100 impact
screwdriver.
2
Printed: 07.07.2013 | Doc-Nr: PUB / 5070690 / 000 / 00
3 / size and
8
Anchor products
9 / 1 / L
16 2
1 / 1 / L
2 2
9 / 1 /
16 2
1 / 1 /
2 2
1 /
2
1 /
2
4
drop in line voltage resulting in loss of power and over-
heating. The following table shows the correct size to
use depending on cord length and nameplate ampere
rating. If in doubt, use the next heavier gage. The
smaller the gage number, the heavler the cord.
Extension Cord Table
Volts Total Length of Cord in Feet
120 V 0–25
240 V 0–50
Ampere Rating AWG
More Than Not More Than
0 6 18
6 10 18
10 12 16
12 16 14
120 V
6.0 A
60 Hz
0–2200 /min.
Max. 2600 impacts/min.
Performance identical
" square pin with retaining pin
1 /
2
5 lbs
100 Nm / 74 ft. lbs
HUS-H 3 /
8
HUS-H 1 /
2
●
●
●
●
●
●
26– 50 51–100 101–150
51–100 101–200 201–300
16 16 14
16 14 12
16 14 12
12 Not recommanded
HRD-U10/HRD-S10/
HRD-U14
●
●
●
●
●
●
●