Operating Modes - Daga HM-2200 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
the store where you purchased the product in the event of any
doubt.
INSTRUCTIONS FOR USE
Prior to plugging in the product to the mains, check that your mains
voltage is the same as or is within the limits of the one indicated on
the product label. The safety instructions marked at the begin-
ning of this manual must be followed at all times when using this
product.
Follow the instructions that are presented below in order to start up
the appliance:
1. Remove the product from its original packaging taking special
care not to damage any of its parts. Do not use excessive force to
remove the product from the box.
2. Place the appliance on the floor, ensuring that this surface is
completely flat, horizontal, clean and dry.
3. Add the water without exceeding the maximum level marked on
the appliance (approximately 3L). Ensure that the water does not
splash onto the outside of the container while adding it. You can
also use the appliance dry if you wish.
4. Connect the appliance to the mains.
5. Turn the switch (1) to select one of the 3 operation modes
available.
6. Put your feet into the water while remaining seated in a seat next
to the appliance and relax while enjoying your hydrotherapy session.
The recommended duration for each session is 15 minutes. If you
wish to have an additional session, rest for around 15 minutes
before starting again.
This appliance includes s a heater cable that covers a large section
of the water container base. This therefore allows you to add the
water directly at room temperature, while the appliance heats it up.
You can still add water that has been already heated using other
means to this appliance if you wish to reduce the time spent on
performing this task. The appliance will ensure that the temperature
remains stable, preventing it from cooling down.

Operating modes:

This appliance comes with three different operating modes. The
therapeutic heat, vibrating massage, air bubbles and infrared light
effects are all combined in each one.
Mode 0: Off.
Mode 1: Infrared and vibration.
Mode 2: Bubbles and heating up.
Mode 3: Vibration, bubbles, heating up and infrared.
Massage rollers:
This appliance comes with a total of four massage rollers. Two of
them are located at the top (2) of the appliance while the other
two are located at the base of the product (6) . Perform forward
and backward movements to support the soles of the feet on the
massage rollers without applying any undue pressure to ensure that
you feel a pleasant sensation.
10
MANUAL HIDROMASAJEADOR.indb 10
22/12/15 18:07

Publicidad

Tabla de contenido
loading

Tabla de contenido