Setup; Turn On The Avr; Configure The Avr For Your Speakers - Sherwood R-607 Instrucciones De Funcionamiento

Setup

Turn On the AVR

1
Set the AVR's Main Power switch to "On".
(The Standby indicator will glow red.)
2
Press the front-panel On/Standby button.
Main Power Switch Standby Indicator
On/Standby Button
On the remote control, you can only turn on or off the
AVR to standby mode by following the steps below.
When the power button is pressed on the main unit,
you cannot turn on the main unit even by pressing the
power button on the remote control.
POWER
ON
Button
1
Press POWER ON on the standby mode.
2
Press STANDBY to turn on the standby mode.
Configure the AVR for Your
Speakers
You will be using the following remote control buttons to
configure your AVR:
Left/
Right/
Up/
Down
Buttons
1
Turn on your TV and select the TV input where
you connected the AVR's Composite Monitor
Out connector in Connect Your Audio and Video
Source Devices, on page 10.
Note
• Although you can configure the AVR using only
its front-panel message display, it is much easier
to use the On-Screen Display (OSD) menu
system.
2
Press the remote control's SETUP button. The
AVR's OSD System Setup menu will appear on
the TV.
System Setup
1. Speaker Setup
2. HDMI Setup
3. Audio Setting's
4. Auto Power Control
5. Speakers On/Off
Standby
3
Button
Use the remote's arrow and ENTER buttons
to select "Speaker Setup". The Speaker Setup
menu will appear.
1. Speaker Setup
a. Speaker Setting's
b. Crossover
c. Channel Level
d. Speaker Distance
Setup
Menu
Button
Enter
Button
Return
Button
15