Technical Data - Hella Bi-Xenon Instrucciones De Montaje

Dimensions L x W x H
Diameter, mounting points
Operating voltage range
GB
Power comsuntion
Rated current
Start-up current for max. 8s.
Peak-current during start-up for 1 ms.
Ignition auxillary voltage at idle
Temperature range
Dust and waterproof
Connection cable between ballast unit and
xenon-bulb
Max. line resistance (Impedence) between
ballast unit and power source, e.g. battery
Fusing
Weight
Electromagnetic compatibilty
6
Exchange of the D1S / D2S bulb:
Please observe the following safety instructions when replaving the xenon-bulb.
- Always switch off the worklamp ballast before exchanging the D1S / D2S bulb and disconnect
the power supply.
- Allow the venon-bulb to cool off.
- The glass body of the xenon-bulb is filled with various gasses and metal gasses under pressure
(danger of splintering).
- Wear safety goggles and gloves when exchanging the xenon-bulb.
- Dispose of used xenon-bulbs as hazardous waste.
- Always use the ballast in combination with the D1S / D2S bulb which is placed inside the closed
worklamp.
- Never touch the glass bulb of the xenon-bulb, touch the xenon-bulb at its base only.
Use a clean cloth and alcohol to remove any fingerprints from the glass bulb carefully.
- Connect the D1S /D2S bulb securely in the connector. Incomplete connection can result in damage
to the product or other equipment, oe electric shock.
- The ballast operation is stopped within 1 second if the D1S / D2S bulb is not connected properly.
7

Technical Data

Ballast Unit for Xenon Gas Discharge Bulbs D1S/35W und D2S/35W
For Input Voltage (Direct Current)
12V 24V
136,25 mm x 93,65 mm x 47,3 mm
5,4 mm
9V - 16V 18V - 32V
Approx. 40W Approx. 40W
3A 1,5A
<20A <10A
<50A <30A
1,1 kV 1,1 kV
-40°C to +105°C housing temerature
To DIN 40050 Part 9 Protective System
IP 6 K 9 K (with original plug arrested)
Length up to 3 m,
can be disconnected from ballast unit
150 mOhm 300 mOhm
15A 7,5A
370g 370g
Satisfies Guidline 95/54/EG