brennenstuhl Premium City SH 8005 IP44 Manual De Instrucciones página 9

Premium LED spotlight
Install the lamp (see Fig� A)
Release the screw
plate . Use the assembly plate to mark the positions of the screw holes on the assembly surface.
4
Important: Make sure not to drill into any hidden lines. Guide the power cable through the cable
bushing on the assembly plate and attach it to the wall using the screws
6
Make sure the gasket is seated correctly. Attach the power cable to the lustre terminal
in accordance with Fig. A (N = blue cable,
Reattach the body of the lamp to the assembly plate. To do this, press the unlock button
slide the lamp onto the assembly plate until the unlock button
connection by screwing it to the terminal box
Set the desired direction of the light and tighten the screws. Switch the main power supply on.
Only for model City SH 8005 PIr IP 44, City LH 8005 PIr IP 44 and
City LH 562405 PIr IP 44
The motion detector should not be directed at heat sources such as grills, air conditioners, other
outside lighting, moving cars and exhaust shafts in order to avoid annoying false triggering. For
the same reason, the motion detector should not be installed in areas with strong electromagnetic
interference. Do not direct the device at reflective surfaces such as smooth white walls, swimming
pools, etc.
The technical specifications for the sensor range (max. 10 meter at 180 °) can vary slightly
depending on the installation height and location. The sensor range on the device can also
change if the temperature changes. Before you select the installation location for the device, you
should know that the motion detector reacts most sensitively to movements that run straight
across its range and least sensitively to movements that run directly toward or away from the
motion detector (see Fig. C). If the movement is directly toward or away from it, this means a
significant reduction of the sensor range (see Fig. C).
There are two controllers on the motion detector (see Fig. D)
Time setting (TIME):
The length of the duration that the lamp remains on after activation can be set to between 10
(+/– 5) seconds and 4 (+/– 1) minutes. By turning the TIME controller from (+) to (–), the duration
is shortened.
Notice: If the light has been triggered by the motion detector, the duration restarts with each
detection.
Light setting (LuX):
The LUX controller has an integrated sensor device (photocell) that recognises daylight and
darkness. Symbol () means that the motion detector is triggered during the day and at night
and when set at the () symbol, it only reacts at night.
BA_City_LED-Premium_0486444_150313.indd 9
on the terminal box, press the unlock button
1
Operating Instructions
3
= green / yellow cable, L = brown cable).
locks back into place. Secure the
3
.
1
D
and remove the assembly
and dowels
5
and
3
13.03.15 09:20
.
7
2
9