Tools Needed For Assembly And Alignment - Bosch CM10GD Instrucciones De Funcionamiento Y Seguridad

2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 15

Tools Needed for Assembly and Alignment

Combination Square Must Be True - Checking Combination Square
1. Position square and
draw a light line
3/4" board with
straight top edge
Assembly
Combination Square
10mm Socket
(supplied)
NOTE: A 6mm and a 4mm hex key can be
substituted for the supplied 6/4mm hex key.
drawn line
#2 Phillips Screwdriver
6/4mm Hex Key
(supplied)
2. Flip square (shown in dotted position)
3. Check edge of flipped square against
the drawn line. There should be no gap
or overlap at the bottom end.
no gap or overlap
15