brennenstuhl Primera-Tec Automatic 19.500 A Instrucciones De Uso página 16

041610 Primera-Tec_041610 Primera-Tec Automatik 1 0487903 1
Operating Instructions Primera-Tec
As soon as the computer will be switched on, its
power consumption increases. The intelligent
electronics in the extension socket recognizes this
and switches on the slave sockets automatically.
After shut down of the computer the power con-
sumption decreases again down to the standby.
This will be recognized by the extension socket,
too, and the slave sockets will be switched off
completely within a certain delay.
Naturally, also combinations of TV, radio, receiver
etc. are controllable.
The power consumption of the master device must be
>5W in the energized condition and in the de-ener -
gized condition (standby operation) it must be <100W.
The switching status of the slave sockets will be
shown by the control light "Slaves on".
Automatic switching threshold setting
The suitable switching threshold (Decision, if the
slave sockets shall be switched on or off) at this
model is automatically determined and stored by
the push of a button. If you temporarily do not
require the Master-Slave function, if you wish you
may activate the permanent mode for the slave
sockets. The multiple socket then acts as if the
Master-Slave function was not available. The swit-
ching threshold stored, or the permanent mode,
also remains if the automatic extension socket is
temporarily switched off at the main switch.
16