brennenstuhl Primera-Tec Automatic 19.500 A Instrucciones De Uso página 17

041610 Primera-Tec_041610 Primera-Tec Automatik 1 0487903 1
Primera-Tec
Starting the automatic switching threshold
setting
1. Switch on the automatic extension socket at the
main switch.
2. Plug the master device into the master socket.
3. Set the master device to the standby mode or
switched off mode, if this is not already done.
4. Keep the "Learn" button pressed for approx. 3
secs., until the "Slaves on" lamp begins to flash.
5. The "Slaves on" lamp now flashes for some
seconds.
During this time, the standby power consump-
tion of the master device is automatically deter-
mined and the switching threshold is stored.
6. When the control light "Slaves on" stops
flashing, the setting process is finished.
The automatic extension socket can now be used.
Permanent mode for the slave sockets
Activation
• Proceed as for the automatic setting of the
switching threshold.
• During the time that the "Slaves on" lamp flas-
hes (Point 5), push the button "Learn" again for
approx. 3 secs. The automatic switching thres-
hold setting will be finished and the permanent
mode for the slave sockets will be activated.
Deactivation
• Simply carry out an automatic switching
threshold setting again.
Operating Instructions
17