041518 BA_DARGO.qxp 28.03.19 11:44 Seite 8
D
Operating instructions
6. Only use the supplied power supply unit and cable to power the device.
Use of any other power supply unit can cause damage to the battery or an explosion!
7. If the protective cover is broken, it should be replaced with an original Brennenstuhl® protective
cover before further use of the floodlight.
8. Disconnect the power supply unit from the mains power and switch the floodlight off before
cleaning.
9. To avoid dazzling or blinding, do not look directly into the light.
10. Please note that the product is only IP65-compliant (dust-tight and protected against water-jets)
if the battery pack has been correctly inserted.
The product is not IP65-compliant (dust-tight and protected against water-jets)
- during the charging process
- during use of the USB output
Hot surface
INTENDED USE
This LED floodlight is suitable for general indoor and outdoor lighting.
E
130°
SWITCHING THE FLOODLIGHT ON/OFF– BATTERY OPERATION
Use the switch A on the back to switch the floodlight on.
Press the switch multiple times to set the brightness to 100%, then 50%, then 10% and then "off".
The lower the brightness selected, the longer the floodlight will burn.
If the switch is left in any of its "on" positions for longer than 3 seconds, then pressing it once again
will always turn it off.
If the plug-in power supply is connected and plugged in while the floodlight is switched on,
the floodlight will automatically switch into mains operation with 100% light.
8
SETTING UP AND SWITCHING ON THE FLOODLIGHT
Place the floodlight on a dry and level surface.
The inclination of the floodlight is adjustable.
To do so, loosen the lateral quick release E, turn the
floodlight head into the desired position and lock the
quick release E again.
DARGO