Receiving A Call - brennenstuhl TRX 3500 Manual De Instrucciones

D
Operating Instructions
CAUTION!
•
Incorrect positioning of the batteries may damage the batteries as well as the device.
•
There is a danger of explosion if the wrong type of battery is used.
•
Dispose of used batteries according to the instructions.
3.3. Battery Indicator
The PMR walkie-talkie detects the battery level and displays it as follows:
•
Battery is full or almost full:
•
Battery is low or empty:
Note
•
To ensure good communication the batteries should be replaced as soon as the 'low battery'
symbol is displayed.
4. OPERATION
4.1. Switching the PMR Walkie-Talkie ON and OFF
To Switch ON
•
Press and hold the
on the LCD screen.
To Switch OFF
•
Press and hold the
4.2. Call Button (Ring Tone)
The CALL button can be used to send a ring tone to other users on the same channel.
•
Press and release the
if it is tuned to the same channel and is within transmission range.
4.3. Adjusting the Speaker Volume
There are 8 volume levels, with the current volume setting being displayed on the LCD screen.
•
To adjust the speaker volume, press the
(DOWN) button to lower it. The volume symbol will be displayed on the LCD screen as a set
of bars that either increase or decrease in size.

4.4. Receiving a Call

The device is always in receive mode as long as it is switched on and is not transmitting. When a
signal is received on the currently selected channel the signal reception symbol 'RX' displays on
the LCD screen.
4.5. Transmitting (Sending)
•
Press and hold the PTT button to transmit a voice signal. The LCD screen displays the signal
transmission symbol 'TX'.
•
Hold the device in a vertical position, with the microphone at a distance of 5 cm from your
mouth. Speak into the microphone in a normal voice while pressing the the PTT button.
•
Release the PTT button when you are fi nished transmitting.
10
BA_PMR_Walkie_Talkie_TRX_3500_0486178_617_.indd 10 BA_PMR_Walkie_Talkie_TRX_3500_0486178_617_.indd 10
displays without blinking
blinks continuously
(On/Off ) button. A specifi c beep is heard. The active channel is displayed
(On/Off ) button. A specifi c beep is heard and the LCD screen goes dark.
(Call) button. The device sends a 2-second ring tone to the other device
PMR Walkie-Talkie TRX 3500
(UP) button to increase the volume or the
28.06.17 12:49 28.06.17 12:49