BLACK&DECKER BEHT200 Manual De Instrucciones página 8

English
Always hold the trimmer, as shown in Fig. G, with one
hand on the switch handle and one hand on the bail
handle. Never hold the tool by the blade guard.
Fig. H
3. TRiMMing nEW gROWTh– (Fig. i) – A wide,
sweeping motion, feeding the blade teeth through the
twigs is most effective. A slight downward tilt of the
blade, in the direction of motion gives the best cutting.

CAUTION:
stems greater than 3/4 in. (19 mm). (Do not use
BEHT200 trimmer for cutting stems greater
than 5/8 in. (16 mm)). Use the trimmer only for
cutting normal shrubbery found around houses
and buildings.
Fig. I
4. lEVEl hEDgEs (Fig. J) – To obtain exceptionally level
hedges, a piece of string can be stretched along the
length of the hedge as a guide.
Fig. J
5. siDE-TRiMMing hEDgEs (Fig. K) – Begin at the
bottom and sweep up.
Fig. K
6
Do not use trimmers for cutting
saw
6. BlADE™ (Fig. l) (BEHTS300, BEHTS400) – For
branches too large for the blade
saw
BLADE™ . Position the
8
to the bottom of the branch as possible. Place the
saw
BLADE™ shoe
9
hedge trimmer on as described above, allowing the tool
to work at its own pace until the branch is fully cut.
Fig. L
9
8

WARNING:
OBSERVE THE FOLLOWING:
• READ INSTRUCTION MANUAL BEFORE USING,
SAVE INSTRUCTION MANUAL.
• CHECK THE HEDGE FOR FOREIGN OBJECTS SUCH
AS WIRE OR FENCES BEFORE EACH USE.
• KEEP HANDS ON HANDLES. DON'T OVERREACH.
• DO NOT USE UNDER WET CONDITIONS.
• DO NOT USE WITH DAMAGED EXTENSION CORD.

DANGER:
FROM BLADES.

CAUTION:
TURN OFF.
MAINTENANCE

WARNING:
from trimmer before servicing, cleaning or removing
material from the gardening appliance.
The cutting blades are made from
high quality, hardened steel and
with normal usage, they will not
require resharpening. However, if
you accidentally hit a wire fence
(Fig. M), stones, glass or other hard
objects, you may put a nick in the
blade. There is no need to remove
this nick as long as it does not
interfere with the movement of the
blade. If it does interfere, unplug
the cord and use a fine toothed file or sharpening stone to
remove the nick. If you drop the trimmer, carefully inspect it
for damage. If the blade is bent, housing cracked, or handles
broken or if you see any other condition that may affect the
trimmer's operation contact your local BLACK+DECKER
Service Center for repairs before putting it back into use.
to cut, use the
1
saw
BLADE™ as close
against the branch. Turn the
1
TO GUARD AGAINST INJURY,
KEEP HANDS AWAY
BLADE COASTS AFTER
Remove extension cord
Fig. M