Assembly; Operation - Wolf Garten Campus 350 RT Instrucciones De Uso Originales

After operating
z After using the unit, disconnected the power
cord from the wall outlet and inspect the unit
for damage.
z When switching off the trimmer: Attention: the
cutting tool does not stop immediately!
z Always wait for the cutting tool is stop.
z Before examining or cleaning the tool or be-
fore removing the safety device or the cord
spool, switch off and disconnect the trimmer
from the mains. Only use original WOLF-Gar-
ten cord spools and note the installation in-
structions!

Assembly

Attach the protective cover
1. Place the protective cover on the lawn trimmer
A
.
2. Attach the protective cover with the fastener
B
3
screws .
Before starting the trimmer, remove the
cut protector on the thread measurer
Assembly of the lawn trimmer
3
Note:
The lawn trimmer can be used for free cut-
L
ting and edge cutting
mation, see the Chapter "Working Position"
Page 14).
z Plug the upper portion of the lawn trimmer into
the lower portion. The connection snaps audi-
D E
bly .

Operation

Operating times
z Please check noise abatement regulations
prevailing in your country.
Set the grip height (Campus 350 RT)
1. Loosen the hand wheel
2. Pull the telescoping section until the ideal grip
height is achieved
3. Turn the hand wheel
G
N
(for more infor-
H
(1).
H
(2).
H
(3).
z The cutting knife should not be cleaned under
running water or under high-pressure.
z Faults shall only be repaired by appointed
service centres or by the manufacturer.
z Make sure all air holes are free of dirt.
z Do not store the unit within reach of children.
Disposal
Do not dispose of electrical equip-
ment in domestic waste. Recycle
equip-ment, accessories and pack-
aging in an environment-friendly
manner.
3
Disassembly of the lawn trimmer
In order to be able to change the working
position, one can loosen the upper and low-
er sections of the lawn trimmer.
z Campus 250 RT: Press both locks of the
upper section together
both sections apart
z Campus 350 RT: Press the locks for the
C
.
telescoping section in the direction of the
arrows
apart
Insert power cable into cable holder
The power cable holder in the guide grip prevents
accidental disconnection of the extension cable
J K
.
F
F
(2).
G
(1) and pull both sections
G
(2).
(1) and pull
13