Agrator Rotary Tillers Are Supplied Without Oil; Standard Rules For The Whole Range Of Agrator Rotary Tillers - Agrator ALR Instrucciones De Uso

AGRATOR ROTARY TILLERS ARE SUPPLIED WITHOUT
OIL
BEFORE STARTING THE WORK FILL WITH OIL SAE 90 UNTIL THE LEVEL THE
CENTRAL GEAR BOX AND THE SIDE TRANSMISSION
I – COUPLING TO THE TRACTOR'S THIRD POINT SYSTEM

STANDARD RULES FOR THE WHOLE RANGE OF AGRATOR ROTARY TILLERS:

1.- Check if the size of the hitching pins correspond to the hole of the arm link ball
joints fixed on the bars of the tractor's hydraulic lifting.
2.- You must left the machine over a flat surface, in hitching position.
3.- Put the tractor very slowly before the machine and take the lifting bars to the
hitching pins, fixing them with the adequated lock pins.(Drawing nº 2).
4.- The central tractor's arm must be fixed in the third point of the machine with the pin
that the tractor has.
5.- The PTO shaft for connecting the rotary tiller to the tractor is supplied with the
same, and you must fix the machine's universal joint by the side of the clutch, being
sure that the fixation pins of the said clutch are correctly put in the groove of the
machine's universal joint. You must repeat the same operation with the orther side
of the universal joint and the tractor's pto shaft.
6.- After this, tighten the stabilizing bars or the screws of the press that the tractors
have for securing the fixation of the machine, without swayings.
7.- After stepping the tractor's clutch for avoiding the work of the machine or lefting
the connection lever(we will talk later aout it) in dead centre, you must lift slowly
the hydraulic lifting for checking if the pto shaft is put in the correct position. We
recommed, for a good conservation of the universal joint,to left a play of 5 cm.
whem the AGRATOR is in working position (Drawing 2).
In the case that this is not got, you must correct the position of the machine by
means of the third point's screw of the press.
8.- If after performing the previous operations the perfect coupling is not achieved, the
tractor's bars must be elongated, but NEVER THE PTO SHAFT MUST BE
SHORTENED, because in this case the warranty is not granted. (Drawing nº 2).
9.- Don't lift the machine when is turning at a distance of more than 25 cm. from the
ground to the rotor axle. If the lifting is too much, the pto shft can be broken.
'' DON'T FORGET IT....''