Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
HCE 73
The site of work the device must provide a sufficient input air of at least 105 cm2 section in both the
top and bottom; have a minimum volume of 84 m3 and existing furniture, 2 m3 maximum.
We recommend not to use the stove in a room very frequent use of aerosols.
Connection of the apparatus
The apparatus can be connected to the gas bottle by the user without recourse to a fitter/technician.
In order to do so you should have at hand the required accessories.
Required accessories
1 gas bottle of butane or propane, bottled only by Oficial Distributors.
§
1 standardised specifications pressure regulator.
§
1 flexible gas tube with at least 0.5m
§
2 screwed collar-clips for the flexible tube. In order to identify these elements, consult
§
the specifications plaque and contact your gas distributor.
Check the characteristics plate and contact your gas provider.
§
ASSEMBLING
Once the heater has been taken out of its packaging:
• Remove the back panel from inside the apparatus.
• Connect the flexible tube to the gas inlet coupling of the heater and to the regulator, ensuring a
gastight fit with the collar clips well screwed down. Avoid twisting the hose.
• Place the gas bottle on the base and fit the regulator to the bottle. On opening the regulator,
check that there are no gas leaks by applying soapy water with a paintbrush at the union of the
flexible tube with the heater and with the regulator.
• Fit the back panel using the attached fixing lugs.
Note: Changing of the bottle should be carried out in a non-flammable environment.
The heater incorporates a safety device which extinguishes the pilot flame if the ventilation in the
premises is insufficient. It is usual for this device to operate in very small premises and if the heater
does go out, ventilate the room well and wait a few minutes before reigniting the heater.
CHECKING FOR GAS LEAKS
Before performing the test, extinguish all the flames and turn off all the electrical appliances. Do not
smoke while checking for gas leaks.
− The test must be performed outdoors or in well ventilated rooms.
− Check that the gas valve is closed.
− Prepare a solution of water and soap using equal amounts of each one.
− Using a brush, apply the solution on the joints between the cylinder, the regulator and the
heater.
− Open carefully the valve.
12
Publicidad
Tabla de contenido
