RADIO FREQUENCY IDENTIFICATION AREA:
The Composite Ti is supplied with an RFID card, that is used to identify the
parameters and types of granules. Please note that the granules RFID card
can increase the single machine's specific working time. The card is dispo-
sable, one card can only be used once.
INTERFACE
Main Interface:
First line: Displayed DMX address is "1".
Second line: Displays the present inner core tempera-
ture and the temperature progress bar; the displayed
remaining time is 7 minutes and 24 seconds.
Error information display table:
Error Information
E0 System IC
E2 Temp. Sensor
E3 P Temp. Over
E4 Time Remain
E5 K Temp. Over
E6 Heat Fail
SETTING INTERFACE:
Press "MENU" to enter the Setting interface, press the "MENU" button to enter different options
until you return to the main interface.
Options
Range Instructions
Set DMX Address
1-512
Wireless Control
ON/OFF
Manual Fountain
ON/OFF
ADVANCED MENU:
Press "MENU" 3 seconds to enter the advanced setup interface, press MENU key to enter different
options, press MENU during 3 seconds to return to the main interface.
Options
Range
Set Temperature
500-620
Auto Heat
ON/OFF
Density
70-100
Mode Selection
Factory Mode/User Mode
DMX channel
2 / 4 DMX channels
mode
Explanation
System error.
Temperature sensor was damaged.
Chassis temperature too high leads to shut down.
Insufficient granules or remaining time, please swipe RFID card.
Inner core temperature too high, leads to shut down
Heating failed.
Set the DMX address. Machine become a wireless host and can send out
DMX signal when its address is "1++".
Wireless function switch. You can match code when the display shows
"ON"
Manual fountain switch, for testing purposes only.
Explanation
Setup inner Core temperature.
Auto preheat function switch after turn on machine
Adjust the sparks density.
Factory Mode is factory debugging mode, User Mode is
using mode
2 DMX channel is standard mode, 4 DMX channel is spe-
cial mode
www.afx-light.com
3
EN