Channel Number; Set Channel - Reer 5006 SCOPI Manual Del Usuario

Channel Number

The channel number must be the same for both units.
There are 9 possible settings, for the baby unit
1 to 9 stands for channel combinations programmed ex factory between PMR 446 radio
channels and CTCSS encoding. The numbers are only valid for this type of transceiver and
there is no communication with other baby monitors!

Set Channel


Briefly press the MENU button once. The set channel will flash.

Press

Press the PTT button to confirm or simply wait a few seconds.
Set Baby Monitor Sensitivity
You can set the sensitivity of the baby unit in 4 levels.
With initial installation the unit is set to level 4

Briefly press the MENU button three times to access the VOX menu.
The display shows the sensitivity setting as a number on the right (between
Press to select a level between
1 setting for highest distance from the baby cot
2 medium sensitivity setting
3 low sensitivity setting
4 highest sensitivity setting (default setting) with additional talkback function
We recommend level 4 as start position. If your baby cries for a longer period without
breaks you may want to talk to your baby to calm it down. For this set the baby unit to
level 4 to allow you after 20 seconds of transmission to talk back for 10 seconds.

Use these 10 seconds to talk to your baby and calm it down.

Simply press the PTT button on the parent unit and talk to your baby.
As long as your baby is quiet you can speak from the parent unit at any time (if the
volume on the baby unit is not set to 00).
22
to select a different setting.
1
and
English
b 1 b 9
to and for the parent unit
4
.
P 1 P9
to .
1 4
and ).