Maintenance; General Maintenance - Ryobi RB60 Manual Del Operador

Once flat surfaces have been covered, apply polish to curved
surfaces such as car doors and quarter panels. Use small
circular motions. Grip the polisher firmly, allowing the cord
to hang free.
NOTICE:
To avoid damaging the motor from overheating, do not
let your hand cover the air vents.
After applying polish to the entire surface, turn polisher off
by pushing the ON/OFF switch to the right. Wait until the
pad stops rotating before lifting the polisher from the surface.
Unplug the polisher.
For hard to reach areas, such as the underside of bumpers
or side mirrors, apply polish by hand.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
OPERATION
CHANGE TO BUFFING/POLISHING BONNET
See Figure 6, page 10.
Remove the application bonnet by pulling the bonnet edges
over and off the pad. Replace with buffing/polishing bonnet,
attaching it the same way as the application bonnet.
Buff the surface in the same order as it was polished, starting
with large flat surfaces and ending with hard-to reach areas.
Use the same motion as for polishing, a broad sweeping criss-
cross pattern on large flat areas and small circular motions
on all other areas. Remember to let the tool do the work.

MAINTENANCE

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
8 – English
WARNING: