IMG STAGELINE SOUND-4BT/WS Manual De Instrucciones página 11

switch on the SOUND-4BT/WS, press the
button POWER again.
Auto standby:
– when AUX 1, AUX 2 or OPTICAL IN has
been selected:
If the SOUND-4BT/WS does not receive
any audio signal via the respective input,
it will automatically switch to the standby
mode after 15 minutes.
– in the Bluetooth mode:
If the SOUND-4BT/WS does not receive
any audio signal from a Bluetooth
source, it will automatically switch to the
standby mode after 15 minutes. If the
Bluetooth connection is still available
(e. g. because the source has not been
switched off but set to pause), the
SOUND-4BT/WS can be switched on
again by starting the replay at the
source.
6) To switch off the SOUND-4BT/WS, use
the POWER switch (5).
6.1 Operation with a Bluetooth source
Notes:
1. To allow signal transmission, the source must use
the A2DP profile.
2. To ensure the best audio quality, the source
should support the aptX
1) To switch the SOUND-4BT/WS to the
Bluetooth mode, press the button
Bluetooth mode will be indicated by the
blue Bluetooth indicator in the lower sec-
tion of the window (1). The indicator will
flash if no Bluetooth connection has been
established.
2) At the Bluetooth source, switch on the
Bluetooth function. On the display of the
Bluetooth source, the SOUND-4BT/WS
will be indicated by "BT Speaker". Pair the
source with the SOUND-4BT/WS (please
refer to the instruction manual of the Blue-
tooth source, if required).
Once the pairing has been made, the
Bluetooth indicator will light up constantly.
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
® technology.
. The
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
3) Start the audio replay at the Bluetooth
source and operate the Bluetooth source
as desired.
The buttons
mote control may also be used to operate
the Bluetooth source (
7 Specifications
Frequency range: . . . 45 – 20 000 Hz
Amplifier power: . . . . 2 × 30 W
Speakers
Bass speaker: . . . . ∅ 10 cm (4")
Tweeter: . . . . . . . . ∅ 25 mm (1")
Max. sound pressure: 98 dB for each
AUX 1, stereo
Sensitivity: . . . . . . . 500 mV
Impedance: . . . . . . 10 kΩ
Connection: . . . . . . RCA
AUX 2, stereo
Sensitivity: . . . . . . . 440 mV
Impedance: . . . . . . 9 kΩ
Connection: . . . . . . 3.5 mm jack
OPTICAL IN: . . . . . . . supports up to
SUB OUT, mono
Level: . . . . . . . . . . . 160 mV max.
Connection: . . . . . . RCA
Bluetooth version: . . . 4.0
Power supply: . . . . . . 230 V~ / 50 Hz
Power consumption: . 170 VA max.
Ambient temperature: 0 – 40 °C
Dimensions: . . . . . . . 140 × 215 × 170 mm
Weight (pair): . . . . . . 5,2 kg
Subject to technical modification.
, and on the re -
chapter 1.2).
RMS
2 × 50 W
MAX
speaker system
192 kHz/24 bit (sam-
pling rate/resolution),
connection via Toslink
(W × H × D)
11