Ryobi P131 Manual Del Operador página 5

 Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
 Latches should snap into place to ensure charger is
correctly connected.
 Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.
 The battery pack may become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
 After charging is complete, the green LED will remain
on until the battery pack is removed from the charger or
charger is disconnected from the power supply.
 To remove the battery pack from the charger, depress
latches and pull up on the battery pack.
 When the battery pack is fully charged, remove it from
the charger.
LED FUNCTIONS
See Figure 2, page 8.
MODE BATTERY PACK
Power
Without battery
pack
Hot battery pack
Testing
Cold battery pack
Deeply discharged
Error
Error
• Try to repeat the conditions a second time by removing and reinstalling the battery pack. If the LED Error status repeats a
second time, try charging a different battery.
• If a different battery charges normally, dispose of the pack that received the Error (see your battery pack manual for instructions).
• If a different battery also indicates Error, the charger should be replaced.
Charging
Fast charging
Full
OPERATION
RED LED
ON
Flashing
Flashing
Flashing
Flashing
ON
– OFF
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may be-
come hot. A hot battery pack may be placed directly onto
the charger port but charging will not begin until the battery
temperature cools to within acceptable temperature range.
When a hot battery pack is placed on the charger, the red
LED will begin flashing. When the battery pack cools, the
charger will automatically begin charging.
CHARGING A COLD BATTERY PACK
A cold battery pack may be placed directly onto the charger
port but charging will not begin until the battery temperature
warms to within acceptable temperature range. When a
cold battery pack is placed on the charger, the red LED will
begin flashing. When the battery pack warms, the charger
will automatically begin charging.
GREEN
LED
OFF Ready to charge battery pack
When battery pack reaches cooled temperature, char-
OFF
ger begins fast charge mode.
When battery pack reaches warmed temperature,
OFF
charger begins fast charge mode.
Charger pre-charges battery until normal voltage is
OFF
reached, then begins fast charge mode.
Flashing Battery pack or charger error.
Flashing Battery is being charged.
ON Charging is complete; charger maintains charge mode.
5 — English
ACTION