SILANOS N1300 DOBLE Manual De Istrucciones página 26

PROBLEM
THE MAINS LIGHT FAILS TO SWITCH
ON
THE WASH CYCLE FAILS TO START
POOR WASHING RESULTS
INSUFFICIENT RINSING
THE GLASSES AND CUTLERY ARE
STAINED
WATER IN TANK AFTER DRAINING
DISHWASHER WITH BUILT-IN OSMOSIS SYSTEM
REPLACING THE CARTRIDGE FILTER OR THE MEMBRANE
It points out that the carbon or mesh filter installed upstream from the dishwasher or the internal
membrane has reached the end of its service life.
Warning: the cartridge filter protects the internal membrane. If it is not replaed in good time, the
membrane will deteriorate irreparably.
High water level in the tank.
When this message is displayed, the filling and rinsing solenoid valve does not activate.
SOLUTIONS:
- Check if there are any obstructions in the drain pipe.
- Check if the drain pump is working correctly.
- Switch off and drain the tank. Switch on again.
- If the problem persists after switching off and on again, call the technical assistance service
and inform them of the type of error on the display.
POSSIBLE CAUSE
Mains not connected
The dishwasher has still not filled.
The holes of the spray arms are
clogged or scale is obstructing
them.
Not enough
detergent or rinse aid
Plates/glasses
correctly.
Too low wash temperature
The set cycle is unsuitable
The spray nozzles are clogged.
Scale in boiler.
The rinse aid is unsuitable or is
not dispensed correctly.
Water hardness above 12°dF or
high dissolved salt content.
The drain pipe is not positioned
correctly or is partially obstructed.
Anomaly or beakage of the temperature probes of the
boiler/tank.
SOLUTIONS:
- Switch off and on again.
- If the problem persists after switching off and on again, call
the technical assistance service and inform them of the type
of error on the display.
POSSIBLE SOLUTION
Check the electric mains connection.
Wait for the triangular Led to switch on.
Dismantle and clean the spray arms.
or unsuitable
Check the type and quantity of detergent.
not positioned
Arrange the plates/glasses correctly.
Check the temperature on the display; if it is
below 50°, call the technical assistance
service.
Increase the wash cycle duration, especially if
the crockery/cutlery is particularly dirty or there
are stubborn leftovers to clean.
Check if the nozzles are clean and if the
softener (if installed) works correctly.
Check the rinse aid container and if it is
suitable for the type of mains water. If the
problem
assistance service.
Check if the pipe and the drain of the
dishwasher are obstructed and if the drain is
positioned too high up; refer to the connection
diagram.
consists, contact the technical
26