Thomashilfen Swifty 2 Manual Del Usuario página 21

User manual – Swifty 2
Folding
NOTE: Be careful not to drop the rehab stroller onto the floor during folding to avoid bending and damaging the frame.
Make sure the plastic plug of the folding mechanism is in the correct position (higher end of the plug is pointing to the
rear of the rehab stroller). (Fig. 1)
CAUTION: The rehab stroller must not be folded up while the sun and rain cover is mounted.
Folding open
The Swifty 2 rehab stroller is equipped with a folding safety device on both push bar joints. To fold it open, the folding
safety device must be released on each side by means of one of the pushbuttons (Fig. 2). Then hold the buggy on the
top and on the side using the push bar and pull it upwards with a swinging movement (the locking slide audibly engag-
es). Loosen the clamping lever at the back and adjust the desired back angle (see the section on backrest adjustment).
Adjust the height-adjustable push bar to the desired position by pressing the side pushbuttons (Fig. 3).
Folding closed (smallest folded size)
Loosen the clamping lever at the back. Pull up the locking slides on the push bar (right and left). (Fig. 1) and hold onto
the safety bow mounted on the right-hand side. Using your upper body, push the push bar forward and fold the buggy
closed in a forward direction (Fig. 4). Press the backrest downwards and tighten the clamping lever again. Fold down
the push bar on the backrest.
The folding lock can be used to prevent accidental unfolding of the Swifty 2 rehab stroller. For this purpose, release the
button on each side of the folding lock (fig. 2), guide the strap around the front frame and push the button closed again.
Now the Swifty 2 can be securely gripped and transported using the tubes of the frame.
Seat and back pads
The seat and back pads consist of a single unit. It is pulled over the backrest in such a manner that the red Swifty logo
is at the front and the lower part of the pad comes to rest on the seat. The rear of the pad is divided into two parts and
is closed with a zipper. Guide the two halves of the pad's back under the Swifty 2's rear bow (Fig. 5). Pull the pad into
place and close the zipper (Fig. 6). Finally, close the hook and loop closure at the lower end of the back (Figure 7).
Seat side guide pad
The opening of each seat side guide pad should point outwards/forwards. (Fig. 8) Pull the pad over the seat side guide
(Fig. 9). Close the zipper. (Fig. 10)
H-belt
The Swifty 2 rehab stroller is equipped with an H-belt as standard equipment.
Opening the belt buckle
To open the H-belt, press and hold the red pushbutton (1), open the clip lock (2 and 3) and release the belt (child safety
lock). (Fig. 11)
Adjusting the shoulder belt height
Open the zipper on the back pad. Open the upper folding buckles and pull the belts out from the front. Undo the back
pad to the desired height using the stitched seam. Pull the straps through the resulting slots and secure them again in the
folding buckles. Close the pad again. (Figs. 12-13)
Removing the H-belt
Open the zipper on the back pad. Open the folding buckles and pull out the H-belt from the front.
21