Publicidad
ENGLISH
OVERLOAD
If the motor is overloaded as a result of too much pressure or because of unsuitable or worn out blade, the internal termal protection overload
will automatically cut off the power.
Wait a few minutes for the motor to cool, then push the green start button.
IMPORTANT ADVICE
• The manufacturer declines all responsibility for loss or damage resulting from misuse or any modification or alteration that does not conform
to the manufacturer's original specifications.
SPARE PARTS ORDERING
When ordering spare parts, please mention machine serial no., part no. and description.
FAULT FINDING
1. THE MACHINE DOES NOT WORK
POSSIBLE CAUSES
Not plugged in properly or cable damaged
No mains voltage
Switch defective, motor cable damaged
Motor faulty (burned out)
Overloaded motor triped
2. NO WATER SUPPLY
POSSIBLE CAUSES
No water supply
Pump does not work
3. THE PUMP DOES NOT START
POSSIBLE CAUSES
The mains lead is not correctly connected or is damaged
No voltage in pump circuit or mains supply circuit
MAINTENANCE
***
Prior to any maintenance work, the machine must be disconnected from the power supply.
•
Clean the machine daily.
•
Drain the water reservoir regularly.
•
Remove all mud and silt deposits in order to avoid the clogging of the water pump.
•
Rinse water pump filter daily.
•
Check daily that the rails are kept clean.
•
In the event of uneven or sluggish cutting, the blade must be cleaned by pressing a silicat or any other
PS353-100; PS353-120
- Make sure that the supply is correctly
plugged in (plug, extension lead, etc.)
- Check the supply cable
- Test or have tested by an electrician (circuit breaker, plug, etc.)
- Have tested by an electrician or contact the service department
- Contact the service department to have the motor replaced.
- Wait a few minutes for the motor to cool down.
- Press green start button
- Fill up clean water in water tank
- Clean strainer
- Check the mains lead
- Check the pump circuit and mains supply
-11-
REMEDIES
REMEDIES
REMEDIES
circuit
abrasive stone lightly against it while spinning.
APR.2015
Publicidad
