Listening To The Radio; Rds Broadcasting - Panasonic RF-U350 Instrucciones De Funcionamiento

Listening to the radio

1
Turn on the unit's
power.
Press .
To turn the power off, press
the button again.
Note
When the power is turned on
again, the broadcast station that
was last tuned in when the power
was turned off, will be tuned in.
Standby/on switch (
Press to switch the unit from on to
standby mode or vice versa.
In standby mode, the unit is still
consuming a small amount of power.
Making it easier to understand
what's being said (RF-U350 only)
You can adjust the speed of what's being said to
understand newscasts, the dialogue of characters in
dramas, etc. better.
Press .
• The indicator around
• To close the slow speech function, press the button
again. (The indicator around
Note
• When the slow speech function is activated, the sound
quality will automatically be switched to NORMAL and
cannot be changed.
• The slow speech function effects may not be obtained with
some music programs and other broadcast content.
• The slow speech function is released in the following cases:
(1) When the power is turned off
(2) When you have changed the station you are now
listening to
• When the slow speech function is set to ON, the tone quality
will change, and there will be a delay in the sound heard.
• The speed of the slow speech function cannot be changed.
• When the slow speech function is set to ON while the
reception is poor and accompanied by a lot of noise,
the noise will be amplified, making the sound hard to
listen to. At a time like this, set the function to OFF.
4
4
2
Select the broadcast station.
Turn
Automatic tuning
When
stops at the station which is tuned in first. Repeat this
until the station you want to listen to is tuned in.
Note
Depending on the quality of the reception, automatic tuning may not be
possible.
• During tuning press
The illustrations
)
show
RF-U350.
now lights.
now goes off.)
to select the desired station.
is pressed, automatic tuning starts, and it
to stop.
3
Adjust the volume.
Turn
volume. (0 to 50)
To improve reception
Adjust the length and angle of the rod
antenna to obtain the best reception.
Note
If you take hold of the unit's rod antenna
and move it from one place to another,
you may damage the unit.
To move the unit, make sure you pick it
up by the handle on the rear panel, and
then move it.

RDS broadcasting

This unit can display the text data transmitted by the radio
data system (RDS) available in some areas.
The panel display is automatically switched when a
Program Service name (PS) or Radio Text message
(RT) is received.
When a Program Service name
(PS) is received
Note
• RDS displays may not be available if reception is
poor.
• During timer operations the unit will not automatically
switch over to the RDS displays. To indicate the RDS
displays, press
"TUNED" appears for
about 1 second when a
station is tuned in.
to adjust the
When a Radio Text message
(RT) is received
.
Handle