Bosch Sensixx B20L Instrucciones De Uso página 14

• This appliance has been designed exclusively
for domestic use and must not be used for
industrial purposes.
This appliance must be used only for the
purposes for which it was designed, i.e. as
an iron. any other use will be considered
improper and consequently dangerous. The
manufacturer will not be held responsible for
any damage arising from misuse or improper
use.
• This appliance is to be connected and used in
accordance with the information stated on its
characteristics plate.
• This appliance must be connected to an
earthed socket. if it is absolutely necessary to
use an extension cable, make sure that it is
suitable for 16a and has a socket with an earth
connection.
• if the safety fuse fitted in the appliance blows,
the appliance will be rendered inoperative. To
restore normal operation the appliance will
have to be taken to an authorised Technical
Service Centre.
• in order to avoid that, under unfavourable
mains conditions, phenomena like transient
voltage drops or lighting fluctuations can
happen, it is recommended that the iron is
connected to a power supply system with a
maximum impedance of 0.27Ω . if necessary,
the user can ask the public power supply
company for the system impedance at the
interface point.
• The appliance must never be placed directly
under the tap to fill the water tank.
• Unplug the appliance from the mains supply
after each use, or if a fault is suspected.
• The electrical plug must not be removed from
the socket by pulling the cable.
• never immerse the iron in water or any other
fluid.
• Do not leave the appliance exposed to weather
conditions (rain, sun, frost, etc.)
Important :
▪
This appliance reaches high temperatures and
produces steam during use, this could cause
scalds or burns in case of improper use.
▪
The steam hose, base station and in particular
the iron can get hot when used.
▪
never aim the steam at people or animals.
▪
Do not allow the power cable to come into
contact with the soleplate when it is hot.
14
B OS C H
Description
1. Water tank
2. removable iron pad *
3. Steam hose storage fixing
4. Carrying handles
5. Mains cable storage compartment
6. Mains cable
7. Steam hose
8. "Steam ready" pilot light
9. "refill water tank" pilot light *
10. "on / off" pilot light *
11. Main power switch (0/i)
12. Housing with internal steam generator
13. Temperature control knob
14. Steam release button
15. iron pilot light
16. Steam button lock *
17. Soleplate
* model dependent
a
preparations
1. remove any label or protective covering from
the soleplate.
2. place the appliance horizontally on a solid,
stable surface.
model dependent:
you may remove the iron pad (2*) from the
appliance and place the iron on it on another
solid, stable, horizontal surface. never rest the
iron on the appliance without the iron pad!
3. Fill the water tank, making sure not to pass the
level mark.
4. Unwind the mains cable (6) fully and plug it
into an earthed socket.
5. Set the main power switch (11) to the "i"
position.
6. The "Steam ready" indicator lamp (8) will light
up after several minutes, indicating that the
appliance is ready to use.
The steam generator will take more time to
reach "Steam ready" state only upon the initial
heating up, or after performing the de-scaling
operation (Calc'n clean).
When water is already present in the steam
generator during regular use, heat up time to
reach the operating temperature will be faster.
7. This appliance has a built-in water level
sensor. The "refill water tank" indicator (9*) will
light when the water tank is empty.
or (model dependent):