Operating Elements And Connections; Safety Notes - Monacor TVCCD-500COL Manual De Instrucciones

Please unfold page 3. Then you can always see the
operating elements and connections described.

1 Operating Elements and Connections

1.1 Camera rear panel (fig. 1)
1 Electronic shutter On/Off
2 Automatic gain control (AGC) On/Off
3 Control Red for manual white balance
4 Control Blue for manual white balance
5 Power supply connection 12 V , center contact = positive
pole
6 Automatic white balance On/Off
7 Video output, 1 Vpp at 75 Ω
8 Connection jack for video signal controlled lens, pin con-
nection for enclosed plug see fig. 2
9 Input for external synchronization, 0.5 V up to TTL level
1.2 Pin connection of the plug for video-controlled
lenses (fig. 2)
1 Output supply voltage 12 V
2 Ground
3 Not connected
4 Video output, 1 Vpp

2 Safety Notes

•
This unit is in accordance with the EC directive no.
89/336/EWG for electromagnetic compatibility.
•
Protect the camera against humidity, heat, and dirt.
•
The CCD image sensor chip must be protected against
dust or other impurities and must not be touched with the
fingers in any case.
•
For cleaning only use a dry cloth for dust removing, by no
means chemicals or water.
•
If the camera is used for other purposes than originally
GB
9