Programmable Feature Call - EnGenius FreeStyl 2 Manual De Usuario

b. Press
SELECT left soft key to confirm your selection for
receiving or blocking line calls.
Press CHANGE left soft key to switch between On and
Off of this setting.
Re: "On" means to be able to receive calls from outside
line; "Off" means to restrict calls from outside line.
The default setting is "On".
c, Press
SELECT left soft key to confirm your selection for
receiving or blocking intercom calls.
Press CHANGE left soft key to switch between On and
Off of this setting.
Re: "On" means to be able to receive intercom calls
from other handsets or base station; "Off" means to
restrict intercom calls from other handset or base
station. Default setting is "On".

Programmable Feature Call

1. If the FREESTYL V2 base station is installed behind a PBX system, you may want
to pre-program some feature calls along with the PBX's feature codes into the
handset(s).
2. Up to 10 most frequently used feature call codes can be pre-programmed.
3. Naming and entering feature call codes:
a. Press
MENU (Right) soft key while the handset is in
standby mode.
b. Press "4", followed by "4" to enter the "Feature Call"
menu.
c. Press
ADD (Left) soft key to add a new entry.
d. Key in the name for the feature call, press
soft key to confirm.
SAVE (Left)
~45~
e. Key in the feature call code of the correspondence PBX
feature i.e. F＊70 (Nortel transfer code).
Press SAVE (Left) soft key to confirm.
Re: "F" represent the Flash signal.
Note: To enter "F" press the talk key.
st
f. The 1
feature call and correspondence feature call
code you entered will appear on the LCD screen.
g. Press
OPTION (Right) soft key to delete or edit the
feature call you programmed into the handset.
h. Repeat the same operation to enter additional (up to
ten) feature call entries.
4. How to use a pre-programmed feature call during an active
phone call.
a. Press
OPTION (Right) soft key while the handset is in
talk mode.
b. Press the corresponding number of the feature call of
which you want to use, i.e. press "0" to perform the
"PBX Transfer" in the example.
Notes:
1. This feature call would be useful if the FREESTYL V2 base station is
connected behind a PBX system.
2. If you have not pre-programmed any feature calls into the system,
only the "#.Phonebook" will show in the
3. The FREESTYL V2's programmable feature call may not function
with all PBX or Key phone systems due to the diversity of various
proprietary systems.
OPTION menu.
~46~