Tabla de contenido
Publicidad
Mechanical installation
4.5.2
Installing the manual release
12.1
Fig. 14
Applying the manual release lever
2. Put both levers completely (12.1) onto the second stator (1A). To do this, push in the plates' pins into
the corresponding holes of the stator (using a suitable tool).
NOTICE
The plates are not symmetric. The pin with the greater distance from the axis of rotation must
be oriented towards the outside. The lever must also face outwards.
Fig. 15
Installation of the tension rods
3. Assemble four pre-assembled tension rods (12.14) with one spring (12.5) each
Carry out steps 4 and 5 separately for each side of every lever.
INTORQ | BA 14.0196 | 04/2016
15
1
3A
1A
12.11
12.8
1A
12.5
12.14
12.14
12.5
30
Publicidad
Capítulos
Tabla de contenido
