Electrical Connection Diagram - Astralpool 32382 Manual De Instalación Y Mantenimiento

Fixed colour: Selection of a fixed colour from twelve possibilities.
Automatic colour sequence:: Selection from among nine programmes of colour sequences. Each programme is defined by
the duration of each colour and of the transition from one colour to another, according to the following table:
For example, programme 5 indicates that each colour remains for 30 seconds, the colour is fixed for 22 seconds and the
other 8 seconds are used to change into the next colour. Programme 8 indicates that the 60 seconds corresponding to each
colour are used to change to the next colour.

6.2.3. Electrical connection diagram

In both TOP and ECO configurations, two cables should be connected in the two 12VCA terminals of the feeder in parallel
with any spotlight (12 V Mains), as if it were another Colorplus spotlight.
The feeder will therefore interpret the signal received and will perform the same functions as the Colorplus spotlights.
To control the projectors with a modulator receiver and/or remote control, connect the synchronism cable from the output of
a 12V transformer to the feeder. The 12V of the transformer itself can feed large projectors (if there are any), or the 12V of
a 50W transformer or more, in cases of installations with Mini projectors only.
** Attention: The pushbutton of the feeder has operation priority and should be disconnected if used jointly with the
Colorplus series of spotlights. If it is not disconnected, the spotlights will not work correctly.
COLOUR Nº % RED
1 100
2 0
3 0
4 100
5 100
6 0
7 0
8 100
9 0
10 100
11 100
12 100
SEQUENCE COLOUR TIMING (SEG.)
1
2
3
4
5
6
7
8
9
% BLUE % GREEN
0 0
100 0
0 100
60 0
0 60
100 60
60 100
100 0
100 100
0 100
100 80
80 100
BLENDING TIMING (SEG.)
4
8
15
15
30
30
60
60
120
-6-
COLOUR
Red
Blue
Green
Magenta
Faint yellow
Bluish cyan
Greenish cyan
Purple
Cyan
Yellow
Bluish white
Greenish white
1
8
4
15
8
30
15
60
60