STEINEL IS 2160 Instrucciones De Montaje página 13

Installation
The site of installation
should be at least 50 cm
from a light because heat
radiated from it may trig-
ger the sensor uninten-
tionally. To obtain the spe-
cified reach of 12 m, the
sensor should be installed
at a height of approx. 2 m.
Please ob-serve the safe-
ty warnings on page 12.
Installation procedure:
1. Undo screws on hous-
ing  2. Do not detach
wir-ing from terminal
block, but gently pull
entire terminal assembly,
including sensor unit 
(cylindrical section), to
remove it.
3. Hold mounting plate 
against wall/ceiling, mark
drill holes, paying atten-
tion to wiring runs con-
cealed in wall/ceiling. Drill
holes, insert wall plugs
(6 mm). 4. Break open
pre-punched cable entry
holes as appropriate for
concealed  or surface-
mounted  installation,
insert grommets, pierce
and pass cable through.
Installation with swivel mount
The swivel mount  allows
you to turn the motion
detector horizontally. This
provides additional adju-
stment for the detection
zone.
1. Press cupped pieces
 out of swivel mount 
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
Note: For surface-mount-
ed wiring, it is recommen-
ded to install the swivel
mount  (see below).
Alternatively, the unit may
be pierced at the thinner
section to pass the cable
through. 5. Screw mount-
ing plate  to wall.
6a) Connecting the
mains lead
The mains lead consists of
a 2-3 phase cable
L
= phase conductor
N = neutral conductor
PE = protective-earth
conductor
If you are in any doubt,
you must identify the
cables using a voltage te-
ster; then disconnect the
power supply again.
The phase (L) and neutral
conductor (N) are connec-
ted according to terminal
assignment. The protecti-
ve-earth conduct-or is
connected to the earth
terminal .
A mains switch for 'ON'
and 'OFF' switching can
of course be installed in
the mains lead.
provided with sensor unit.
2. Hold swivel mount 
against wall and mark drill
holes, drill the holes, insert
wall plugs, pass cable
through. Connect as de-
scribed in „Installation".
3. Pass screws through
(s. fig. page 3)
6b) Connecting the load
supply lead
The load supply lead (e.g.
light) is also a 2 to 3-core
cable which is connected
to terminals N and L'. The
live conductor must be
connected to the terminal
marked L'.
Connect the neutral con-
ductor to the terminal
marked N together with
the neutral conductor of
the mains power supply
lead. The protective-earth
conductor is connected to
the earth terminal
7. Once wiring is complet-
ed, insert terminal block
together with sensor unit
 into mounting plate ,
fit housing cover  and
secure in place with faste-
ning screws.
cupped pieces  and
secure swivel mount  in
such a way that the screw
head is positioned on the
smooth side and the
domed side rests against
the mounting plate  (see
diagram).
.
13