Bosch GKF125CE Instrucciones De Funcionamiento Y Seguridad página 12

2610052572_GKF125CE 9/18/18 12:11 PM Page 12
FIG. 9
DEPTH SCALE
6. Lower the motor until the target
scale value is reached.
7. Turn the clamping knob to the
middle position
adjustment (C, Fig. 9). Always
make sure the motor is held tightly
in the base.
8. Check the depth-of-cut and make
fine adjustment if necessary (D,
Fig. 9).
ADJUSTMENT section below for
details.
9. Turn the clamping knob to the
bottom, locked position
9). Always make sure the motor
sits tightly in the base.
Note: the depth of the motor and bit
Operating Instructions
A
B
symbol, for fine
See FINE DEPTH
(E, Fig.
C
may shift very slightly when the
clamping knob is turned to the locked
position.
10. Make a trial cut to verify that the
router is set to make the cut as
desired.
▼ FINE DEPTH ADjUSTMENT
Adjust the depth-of-cut only when the
motor is switched off.
1. Turn the clamping to the middle
position
adjustment (C, Fig. 9).
2. Adjust the desired depth-of-cut
with the knurled wheel on back of
base (D, Fig. 9). Rotate the knurled
wheel clockwise to increase the
12
E
MOTOR
BASE
CLAMPING KNOB
D
KNURLED WHEEL
symbol, for fine