Bosch GKF125CE Instrucciones De Funcionamiento Y Seguridad página 21

2610052572_GKF125CE 9/18/18 12:11 PM Page 21
Note that the adapter is reversible, so
the release lever may be positioned as
desired. (Fig. 26)
▼ CENTERING THE SUB-BASE OR
TEMPLATE GUIDES
Your PR111 plunge base features the
Bosch "Precision Centering Design".
Its subbase is precisely centered at
the factory. This positions the bit at
the center of the subbase and
optional template guides.
Precision centering allows you to use
the edge of the subbase or template
guides to closely follow jigs such as
straight guides, templates, and
dovetail fixtures without worrying
about bit walk-off from the intended
cut line for any reason, including the
orientation of the router's handles
relative to the jig.
To most precisely re-center the
subbase or template guides, attach
the subbase using the optional Bosch
RA1151 Centering Device. Follow
steps 1-8 (Fig. 27).
1. If a template guide is to be
centered, Install the template guide
adapter and template guide
(optional
described elsewhere in this
manual.
2. Loosen the four screws that hold
FIG. 27
PLUNGE BASE
TEMPLATE GUIDE
(optional accessory)
Operating Instructions
attachments) as
CENTERING CONE
(optional accessory)
CENTERING SHAFT
(optional accessory)
SUBBASE
the subbase to the base.
3. Prepare the Centering Device:
• Use narrow end of steel shaft.
• When centering subbase or
template guide that has opening of
more than 1/2", slide the wide
plastic sleeve over the steel shaft.
4. Slide centering sleeve through the
subbase or template guide and into
collet. Tighten collet nut with
fingers to put slight grip on
centering cone.
5. Lightly press centering sleeve into
sub-base or template guide to
center.
6. Tighten the pan-head screws.
Remove centering sleeve.
7. The precision centering of the
subbase or template guide is
complete.
CENTERING CONE – Used when
centering the subbase itself or wide
template guides.
▼ MAXIMUM BIT/CUTTER SIZE FOR
TEMPLATE GUIDES
When using a template guide, use
only router bit with cutters that are
1/16" less than the internal diameter
of the template guide, such as in the
table below.
21
CENTERING SHAFT
(optional accessory)