HIKOKI СС 14SF Instrucciones De Manejo página 8

English
9. Cleaning
Wipe off chip and waste adhered to the machine with a
cloth or the like time to time. Be careful not to make the
motor portion wet with oil or water.
10. Faults in the machine, including guards or cutter blades,
should be reported as soon as they are discovered.
SELECTING ACCESSORIES
The accessories of this machine are listed on page 146.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
GUARANTEE
We guarantee HiKOKI Power Tools in accordance with
statutory/country specifi c regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the Power Tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling instruction,
to a HiKOKI Authorized Service Center.
IMPORTANT
Correct connection of the plug
The wires of the main lead are coloured in accordance with
the following code:
Blue: — Neutral
Brown: — Live
As the colours of the wires in the main lead of this tool may
not correspond with the coloured markings identifying the
terminals in your plug proceed as follows:
The wire coloured blue must be connected to the terminal
marked with the letter N or coloured black. The wire
coloured brown must be connected to the terminal marked
with the letter L or coloured red. Neither core must be
connected to the each terminal.
NOTE
This requirement is provided according to BRITISH
STANDARD 2769: 1984.
Therefore, the letter code and colour code may not be
applicable to other markets except The United Kingdom.
Information concerning airborne noise
The measured values were determined according to
EN 62841.
The typical A-weighted sound pressure level LpA: 105 dB (A);
uncertainty KpA: 3 dB
The typical A-weighted sound power level LwA: 111 dB (A);
uncertainty KwA: 3 dB
Wear hearing protection.
● Information about power supply system of nominal
voltage 230 V~
Under unfavorable mains conditions, this power tool
may cause transient voltage drops or interfering voltage
fl uctuations.
This power tool is intended for the connection to a power
supply system with a maximum permissible system
impedance Z of 0.14 Ohm at the interface point (power
MAX
service box) of the user's supply.
The user has to ensure that this power tool is connected
only to a power supply system which fulfi lls the requirement
above.
If necessary, the user can ask the public power supply
company for the system impedance at the interface point.
● Information about the circuit-breaker switch of
nominal voltage 230 V~
This tool should be used only if it is connected to a 16 A Fuse
with gl disconnection characteristic.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
8