Before Starting The Equipment - EINHELL TE-MX 1600-2 CE Twin Manual De Instrucciones

Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ..................... 89,1 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ..................... 100,1 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Right handle
Vibration emission value a
K uncertainty = 1.5 m/s
Left handle
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Anl_TE_MX_1600_2_CE_Twin_SPK9.indb 16 Anl_TE_MX_1600_2_CE_Twin_SPK9.indb 16
= 1.329 m/s
2
h
2
= 1.739 m/s
2
h
2
- 16 -
GB
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the power
supply make sure that the data on the rating plate
are identical to the supply voltage.
Warning!
Always pull out the power plug before ma-
king adjustments to the equipment.
5.1 Stirrer assembly (Fig. 2-4):
•
Clean the stirrer (b) before fitting it and grea-
se the stirrer shaft a little with suitable grease.
•
Pull back and hold the locking sleeve (a).
•
Push the first dust-free stirrer into the stirrer
mount as far as it will go. Important! The pin
(c) on the stirrer shaft must go into the groove
(d) on the mount (4)!
•
Release the locking sleeve (a). The stirrer will
lock automatically.
•
Check the lock by pulling the stirrer.
•
Repeat the process with the second stirrer.
•
To disassemble, proceed in the reverse order.
5.2 Replacing the stirrers (Fig. 3)
The stirrers can be swapped around in order
to change the direction of mixing.
Left: stirrer 2 / right: stirrer 1
•
The mixture is mixed from the top down.
For fl uid materials such as:
- wall paints
- gypsum-lime plasters
- sealing compounds
30.08.2017 16:10:11 30.08.2017 16:10:11