Safety Regulations; Layout And Items Supplied - EINHELL SA 1100 Manual De Instrucciones

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Ensure that you observe the following points in
order to avoid accidents and injuries.
•
Do not overload your swing arm.
•
Do not continue to use the swing arm if it is
damaged.
•
Ensure that all bolts are tightly fastened and
check them frequently for your own safety.
•
Ensure that the cotter pin is properly inserted
through the bore holes.
•
Lifting and carrying persons with the cable
winch is strictly prohibited! Additionally,
persons may not loiter underneath the cable
winch/swing arm assembly.
•
Persons who are not aware of these safety
precautions may not use this product.
All components must be regularly checked for any
kind of deformation or damage.
Observe the maximum permissible load ca-
pacity (see „Technical Data“)!
GB GB

2. Layout and items supplied

2.1 Layout (Fig. 1/2)
1. Pipe collar (with large hinge pin A)
2. 2x holding bars for pipe collars
2a. 1x holding bar for pipe collar
3. Pipe collar (with small hinge pin B)
4. Support arm
5. Square-edged boom 45 x 45 x 1.8 mm
6. Extension pipe 40 x 40 x 2.5 mm
7. 2x Hexagon bolt M6 x 15 mm
8. 1x Hexagon bolt M12 x 75 mm
9. 1x hexagon nuts M12
10. 1x spring washers Ø 12
11. 1x washers Ø 12
12. 2x pads for clamping brackets
13. Hexagon nut M8
14. Spring washer Ø 8
15. Washer Ø 8
16. Hexagon bolt M8 x 65 mm
17. 6x Hexagon bolt M12 x 65 mm
18. 6x Hexagon nut M12
19. 6x Spring washer Ø 12
20. 6x Washer Ø 12
2.2 Items supplied
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or su ocating!
•
Original operating instructions
- 11 -