EUROM GOLDEN 2000 ULTRA Manual De Instrucciones página 17

 The terrace heater can also be suspended from a ceiling in the same manner. In that
case, the locking wing nut must be replaced with a strong screw (not supplied) that can
be fastened by means of a plug in the ceiling. Check the fastening regularly!
2 – Suspension from a frame (parasol, tent or similar item) by means of a bracket
3 – Suspension from a ceiling by means of chains
hook to the chain allows you to raise the suspension height of the heater (see picture).
Please always take account of the minimum distances to the ceiling, floor, walls and
objects!
The following applies for all options:
 However you install the GOLDEN ULTRA (RCD) c.q. 2500 Ultra RCD, always lead the
electrical cable directly away from the heater. It may not become hot!
 Adjust the desire radiation angle of the device. Do this by undoing both Allen screws
slightly using the Allen key. Make sure you secure them again once you have made the
adjustments! The heater can rotate through approximately 90° - with wall fastening
from 30° upwards to approximately 60° downwards. When adjusting the angle ensure
that the radiator does not radiate heat onto flammable materials from a short
distance!
 Fasten all screws another time firmly and scheck or the heater is firmly mounted. Now
your infra red heater is ready for use.
 For personal protection the installation, to which the EUROM GOLDEN 2000 ULTRA
(RCD) c.q. 2500 Ultra RCD is connected, has to be equipped with an earth fall device
(max. 30 mAmp).
17
 Ascertain that the frame from which you wish to suspend
the terrace heater is strong enough to take the weight of
the terrace heater for an extended period of time.
 Choose which of the three supplied brackets is suitable
for the frame. You must choose the smallest possible
option.
 Slide the bracket around the frame, place the terrace
heater against it and screw the bracket to the suspension
bracket with 2 wing nuts (see picture).

 Choose 2 suspension points in the ceiling, 40 cm apart.
Ascertain that the ceiling and fastening materials are
strong enough and suitable to take the weight of the
heater for an extended period of time.
 Fasten the suspension eyes to the ceiling (not supplied).
 Hook one end of the chains onto suspension points of the
heater by means of the karabiner hook. You hook the
karabiner hooks at the other end of the chain through the
suspension eyes in the ceiling. Pulling the chain through
the suspension eye and fastening the second karabiner