EUROM GOLDEN 2000 ULTRA Manual De Instrucciones página 18

Under some circumstances it may be attractive to make a fast connection between the
heater and the main supply, and to operate the heater with a switch. Because the
EUROM GOLDEN 2000 ULTRA (RCD) c.q. 2500 Ultra RCD has a high water tightness (IP65)
and for safety reasons, such a connection has to be made by a qualified electrician.
WORKING
Check for every use:
- or the appliance doesn't show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating duet o
wind or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V-50Hz) and is
grounded.
When you use the appliance for the first time (or after a long time again), observe it
during the first 10 till 15 minutes to be sure that is works trouble-free.
Golden 2000 Ultra:
If everything is all right you can insert the plug into the socket. The infra red heater will
start to work. To stop the heater, take the plug out of the socket and give the heater time
to cool down.
Golden 2000/2500 Ultra RCD:
The Golden 2000/2500 Ultra RCD has a remote control that works with two batteries:
AAA, 1.5V.
While using, point the remote control to the receiving point of the heater (on the electric
part). If there are obstacles between remote control and the heater, it will not work!
Remove the batteries out of the season, that will extend the life of the remote control.
• Press the on/off switch (7) on the side of the unit to "I" (on)

Set the device into operation by pressing the ON button of the remote control. The
device has a 'slow start' at 33% output (NB. This
requires a fuse type C). 4 seconds after starting, it
automatically switches to the most recently used
output. On first use, it will switch to 100% output
after 4 seconds.

With the Ʌ-arrow, you can switch to a higher heating
level

With the V-arrow, you can switch to a lower heating
level

Pressing on the MAX button takes you straight to the
highest heating level.
 To stop the unit, first press the 'off' button on the
remote control. Then turn it off by pressing the
on/off-switch to 'O' (off). Finally, unplug it from the wall outlet. Allow the heater to
cool down.
Warning! When you turn off the unit using only the remote control, the 'standby'
remains. So turn it off using the remote control or the on/off-switch and remove the plug
from the socket!
18