Controls And Functions; Front Panel Layout; Monitor Section - Samson Audio S-zone Manual De Usuario

Controls and Functions

Front Panel Layout

INPUT SECTION
VOLUME – Rotary control used to adjust the level of
1
signal source connected to channel 1.
ZONE 1 – When the LED Backlit switch is pressed
2
in, the switch lights red and the input is assigned to
ZONE 1.
ZONE 2 – When the LED Backlit switch is pressed in,
3
the switch lights green and the input is assigned to
ZONE 2.
STEREO/MONO switch - This switch is used to
4
select either stereo or mono input.
SCRIBE STRIP – Convenient area for marking the
5
input source allowing you to label the channel with
the device connected to the input.
ZONE 3 – When the LED Backlit switch is pressed in,
6
the switch lights amber and the input is assigned to
ZONE 3.
ZONE 4 – When the LED Backlit switch is pressed in,
7
the switch lights orange and the input is assigned to
ZONE 4.
MIC/LINE 2 – Channel 2 input with the same knob
8
and switch complement as Channel 1.
LINE 3 – Channel 3 input with the same knob and
9
switch complement as Channel 1.
LINE 4 – Channel 4 input with the same knob and
10
switch complement as Channel 1.

MONITOR SECTION

MONITOR SPEAKER – This built-in, miniature super-
11
speaker allows you to listen to the signal that is pres-
ent at any ZONE OUTPUT.
MONITOR VOLUME - This rotary control is used
12
to adjust the monitor level heard in the front panel
Headphone jack or SUPER SPEAKER.
ZONE SELECT switch – This four-position switch is
13
used to assign any of the four Zones to play in the
MONITOR SPEAKER or HEADPHONE JACK.
HEADPHONE JACK - Connect any standard stereo
14
headphone using a standard 1/4-inch jack to moni-
tor the ZONE OUTPUTS.
ZONE OUTPUT SECTION
VOLUME – This rotary control is used to control the
15
overall level of OUTPUT ZONE 1.
HIGH – High frequency equalizer rotary control
16
with +/-12 dB of cut or boost at 10kHz.
OUTPUT METER – Six-segment LED meter display-
17
ing the level of the ZONE 1 OUTPUT with -20 to +14
dB indicators.
STEREO/MONO switch - This switch is used to
18
select either stereo or mono operation on the ZONE
1 OUTPUT.
SCRIBE STRIP – Convenient area for marking the
19
ZONE OUTPUT allowing you to notate the room or
area the zone is feeding.
LOW– Low frequency equalizer rotary control with
20
+/-12 dB of cut or boost at 100Hz.
ZONE OUTPUT 2 – ZONE 2 OUTPUT with the same
21
knob and switch complement as ZONE 1 OUTPUT.
ZONE OUTPUT 3 – ZONE 3 OUTPUT with the same
22
knob and switch complement as ZONE 1 OUTPUT.
ZONE OUTPUT 4 – ZONE 4 OUTPUT with the same
23
knob and switch complement as ZONE 1 OUTPUT.
POWER switch – Use this switch to power the unit
24
on and off.
4