Yamaha RX-V383 Guía De Inicio Rápida página 12

1
Turn on the subwoofer and set the volume to half.
If the crossover frequency is adjustable, set it to maximum.
VOLUME
MIN
2
Place the YPAO microphone at your listening
position and connect it to the YPAO MIC jack on
the front panel.
The screen below appears on the TV.
Note
Place the YPAO microphone at your listening position (same height as your ears).
We recommend the use of a tripod as a microphone stand. You can use the tripod
screws to stabilize the microphone.
12
En
CROSSOVER/
HIGH CUT
MAX MIN MAX
Auto Setup
Start
Exit
3
Press ENTER.
The measurement will start in 10 seconds.
It takes about 3 minutes to measure.
The screen below appears on the TV when the measurement finishes.
Auto Setup
Measurement Finished
Result
3/2/0.1ch
3.0/10.5m
-3.0/+10.0dB
OK : ENTER
Note
If an error message (such as E-1) or warning message (such as W-2) appears,
see "Error messages" or "Warning messages" under "Optimizing the speaker
settings automatically (YPAO)" in the Owner's Manual.
4
Confirm the results displayed on the screen and
press ENTER.
5
Use the cursor keys (e/r) to select "SAVE" (Save)
and press ENTER.
6
Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.