Rear Panel - Peavey PVi PORTABLE Manual De Operación

43) USB flash disk port for USB disk with MP3 files.
44) LED indicator showing the working status of the USB port.
13) MP3 Level - MP3 input level adjustment; essentially the master volume for the MP3 player.

REAR PANEL

®
CONNECTOR/LINE CORD - The PV i PORTABLE is equipped with a grounding-type IEC supply cord to reduce the
possibility of shock hazard. Be sure to connect it to a grounded AC receptacle.
DO NOT ALTER THE AC PLUG.
The power mains (AC) fuse and fuse holder are under the IEC (power cord) socket. Replacement fuses must be of
the same rating (6A 250V) and size as originally equipped. To replace a blown fuse, remove the IEC power cord,
pull out the fuse holder and find the spare fuse inside.
REAR STORAGE COMPARTMENT
A small storage compartment can be found on the rear of the PVi PORTABLE. To access this compartment, simply
lift the latch and pull open the storage door. This compartment is ideal for storing cables, microphones and other
accessories.
SETUP & CONNECTIONS
Before turning on the Power, please read and heed the safety warnings in front of manual.
It is important to establish a routine for connecting and powering up your sound system. Provided you have
a properly grounded AC outlet or outlet strip with sufficient power handling capacity, plug all sound system
equipment into the same outlet or strip. This will enhance system safety and performance. Ensure that the AC
circuit is capable of handling the peak power demands of your system. Consult a qualified electrician if in doubt.
WHEN SETTING UP BE SURE TO FOLLOW THESE SIMPLE GUIDELINES:
1. First, turn all channel Level and EFX/AUX controls to their fully counterclockwise (OFF) positions. Next, place
all graphic EQ sliders in the middle position (0 position), and all Pan and Master controls at 12 o'clock in their
center-notched positions.
2. Next, connect each speaker cable to the appropriate Left & Right Speaker outputs on the front lower right of the
main mixing console.
3. Connect all microphones, tape decks, keyboards, etc., into the appropriate inputs.
4. Finally, check the local voltage and set the voltage selector switch located adjacent to the power input socket on
the rear of the mixer amplifier to the appropriate operating range. (See Safety Precautions) Plug the power cable
into the IEC (power cord) socket and to a properly grounded 3-wire AC power outlet.