Setting The Light Effect; Ln-T4065F / Ln-T4665F / Ln-T5265F; Upgraojng The Software - Samsung LN-T4061F Manual Del Usuario

Setting the Light Effect (LN-T4065F / LN-T4665F I LN-T5265F)
You can turn on/off the blue LED on the front of TV.
1,
2.
3.
Press the MENU button to display the menu.
Press the A or '_ buttons to select "Setup", then press the ENTER button.
Press the _kor T buttons to select "Light Effect", then press the ENTER
button.
Press the A or T button to select "Off', "In Standby", "In Watching TV" or "Always",
then press the ENTER button.
, Off: LED witt n0t come 0n.
, In Standby: Turns the LED on in standby mode.
In Watching TV: "Turnsthe LED on while watching TV.
, Always: LED witi come on after you turn the TV off.
Press the EXIT button to exit.
Upgrading the Software
Samsung may offer upgrades for TV's firmware in the future. Please contact the Samsung call center at 1-800-SAMSUNG
(726-7864) to receive information about downloading upgrades and using a USB drive. Upgrades wilt be possible by connecting a
USB drive to the USB port located on located on the side of your TV.
1, insert a USB drive containing the firmware upgrade into the WtSELtNK port on
the side of the TV.
2. Press the MENU button to display the menu.
Press the A or T button to select Setup, then press the ENTER button.
3, Press the h. or V button to select Software upgrade, then press the ENTER button.
4, Press the A or _' button to select USB Upgrade, then press the ENTER button.
The message Scanning for USB._ It may take up to 30 seconds, is displayed.
Please be careful to not disconnect the power or remove the USB drive while
upgrades are being applied. The TV wilt shut off and turn on automatically after
completing the firmware upgrade. Please check the firmware version after the
upgrades are complete.