Listening Through A Receiver Home Theater; Check Points Before Requesting Service - Samsung LN-T4061F Manual Del Usuario

through a Receiver
_(Home theater)
You can listen to sound through a receiver instead of the TV speaker.
1. Press the Anynet+ button.
Press the A or 'V button to select Receiver then press the ENTER button.
2. Press the 4 or _,- button to select to On, then press the ENTER button.
Now you can listen to sound through the receiver.
3. Press the EXIT button to exit.
When the receiver is set to On, you can listen to the TV sound through the 2-channel receiver.
tf the receiver is exclusively for a home theater only (supporting audio only), it may not appear in the
device fist.
Only when you have connected the optical jack of the TV and the receiver properly, does Receiver work.
tn case of a content with copyright problem, listening through the receiver may not properly operate.
Check Points before Requesting Service
Symptom Solution
Anynet+ does not work. m Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
devices only.
m Connect only one receiver (home theater).
m Check if the Anynet+ device power cord is properly connected.
m Check the Anynet+ device's Video/Audio/HDMt 1.3 cable connections.
m Check whether the TV remote control is in TV mode.
m Check whether it is Anynet+ exclusive remote control.
m Anynet+ doesn't work at a certain condition. (Searching channels, Operating
WISELtNK)
I want to start Anynet+. m Check if the Anynet+ device is property connected to the TV and check if the Anynet+
(HDMI-CEC) is set to On in the Anynet+ Setup menu.
m Press the TV button on the TV remote control to switch to TV. Then press the
Anynet+ button to show the Anynet+ menu and select a menu you want.
I want to exit Anynet+. m Select Watch TV in Anynet+ menu.
m Press the SOURCE button on the TV remote control and select a device other than
Anynet+ devices.
m Press CH, CH LIST, PRE-CH, etc. to change to the TV mode. (Note that the channel
button operates only when a tuner-embedded Anynet+ device is not connected.)
m You cannot use the remote control when you are configuring Anynet+ or switching to a
view mode.
m Use the remote control when the Anynet+ setting or switching to view mode is
complete.
You cannot use the play function when an auto channel scan is in progress or in
WtSELtNK mode. Stop the currently running function.
m Check whether or not the device supports Anynet+ functions.
m Check whether or not the HDMi 1.3 cable is properly connected.
m Check whether HDMI Control is set to On in the Anynet+ setup menu.
m SearchAnynet+ devices again.
m You can connect an Anynet+ device using the HDMi 1.3 cable only. Some HDMi
cables may not support Anynet+ functions.
The Connecting to Anynet+
device.., message appears on the
screen.
The Anynet+ device does not play.
The connected device is not
displayed.