Safety Notes - Monacor DMT-3040 Manual De Instrucciones

8 Button for switching on the display illumination:
keep the button pressed for 2 seconds;
after 15 seconds, the illumination is switched off again
9 Button FUNC. for selecting the measuring function according
to the position of the selector switch (10):
Position of selector switch
TEMP
BATT 9V, 3V, 1.5V
µA, mA, A,
10 Selector switch for the measuring function
The position
clamp adapter. (A matching adapter is presently not available
from MONACOR.)
11 Jack INPUT for the red test lead when measuring voltages,
currents below 200 mA, resistances, and diodes
12 Adapter for connecting transistors; it is plugged into the jacks
COM and INPUT on the meter

2 Safety Notes

This unit corresponds to the directive for electromagnetic compat-
ibility 89/336/EEC and to the low voltage directive 73/23/EEC.
Caution!
With this meter, very high voltages dangerous to life can be
measured. Particular care must be taken when measuring volt-
ages higher than 42 V! When handling the test prods, always
make sure to keep your fingers behind the protection. Never
operate the multimeter if the meter or the test leads are dam-
aged. Damaged test leads must be replaced.
Please observe the following items in any case:
The meter is suitable for indoor use only. Protect it against
dripping water and splash water, high air humidity, and heat
(admissible ambient temperature range 0 – 40 °C).
For cleaning only use a dry, soft cloth; never use chemicals or
water.
No guarantee claims for the meter and no liability for any re-
sulting personal damage or material damage will be accepted
V
Ω
hFE
is provided for measuring currents with a
Option
AC or DC voltage
—
Diode or continuity test
—
°F or °C
—
AC or DC current
GB
15