Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ORIGINAL OPERATING INSTRUCTIONS
DX 462 powder-actuated tool
It is essential that the operating instruc-
tions are read before the tool is operated
for the first time.
Always keep these operating instructions
together with the tool.
Ensure that the operating instructions
are with the tool when it is given to other
persons.
Description of main parts
@ Exhaust gas piston return unit
; Guide sleeve
= Housing
% Cartridge guideway
& Power regulation wheel release button
( Power regulation wheel
) Trigger
+ Grip
§ Piston return unit release button
/ Ventilation slots
: Piston rings
· Piston *
$ Fastener guide *
£ Fastener guide release button
| Buffer *
* These parts may be replaced by the user/operator.
Contents
1. Safety rules
Printed: 08.07.2013 | Doc-Nr: PUB / 5069845 / 000 / 02
1. Safety rules
1.1 Basic safety instructions
In addition to the safety rules listed in the individual sec-
tions of these operating instructions, the following points
must be strictly observed at all times.
1.2 Only use Hilti cartridges or cartridges of equiva-
lent quality
The use of cartridges of inferior quality in Hilti tools may
lead to build-up of unburned powder, which may explo-
de and cause severe injuries to operators and bystan-
ders. At a minimum, cartridges must either:
a) Be confirmed by their supplier to have been suc-
cessfully tested in accordance with EU standard EN
16264
NOTE:
● All Hilti cartridges for powder-actuated tools have
been tested successfully in accordance with EN 16264.
● The tests defined in the EN 16264 standard are system
tests carried out by the certification authority using
specific combinations of cartridges and tools.
The tool designation, the name of the certification aut-
hority and the system test number are printed on the
cartridge packaging.
or
b) Carry the CE conformity mark (mandatory in the EU
as of July 2013).
See packaging sample at:
www.hilti.com/dx-cartridges
1.3 Use as intended
The tool is designed for professional use in fastening
applications in construction where nails, threaded studs
and composite fasteners are driven into concrete, steel
Page
and sand-lime block masonry.
17
19
19
20
1.4 Improper use
21
● Manipulation or modification of the tool is not per-
21
missible.
● Do not operate the tool in an explosive or flammable
22
atmosphere, unless the tool is specially approved for
23
such use.
25
● To avoid the risk of injury, use only original Hilti fas-
29
teners, cartridges, accessories and spare parts or those
30
of equivalent quality.
30
● Observe the information printed in the operating
30
instructions concerning operation, care and mainte-
31
nance.
en
17
Publicidad
Capítulos
Tabla de contenido
