Facom NU-CL.P/1005 Manual De Instrucciones página 13

Using the drill-screwdriver:
- Apply the safety instructions provided in this manual.
- Fit the tool on the chuck: Fit the tool on the chuck: Fit the tool on the chuck: Fit the tool on the chuck: Fit the tool on the chuck: turn the knurled section of the chuck clockwise to open the chuck, then in the opposite direction and
lock tightly to maintain the tool in the chuck.
- Select the running direction: selector mark 2
- Select the rotation speed: selector mark 5 ;
- « high » position: high speed, low torque
- « low » position: low speed, high torque
- Set the rotation strength (torque): selector mark 6; 16 different
screwing torques are available (torque increases according to the number on the selector), and 1 "no torque limitation"position
for drilling.
Torque varies according to the ''high'' or ''low'' position selected.
- To start, press the trigger (mark 1) gradually.
The variator allows for increasing the rotation speed according to the pressure on the trigger.
For safety reasons, the chuck is stopped when the trigger is released.
- To improve visibility, you can switch on the built-in LED light (button mark 3).
Do not omit to switch off the LED light after use (power consumption).
Do not change the speed, rotation direction, or screwing torque while the motor is running.
Recommendations of use:
Accessories:
- Only use accessories adapted to the task at hand and to the machine used; your safety, the quality of your work and the tool
lifetime depend on it.
The FACOM range includes drill bits, screwing bits and screwing sockets suited to your needs
(see <<FACOM accessories>> section).
Drilling:
- When drilling large diameter holes or in tough materials, we recommend starting by making a smaller hole first.
Storage:
We recommend storing your power tools in a dry and temperate location (temperature above 5°C and below 40°C); your
batteries will provide more power.
Heavy use:
- In case of heavy use, allow the machine to cool down a few minutes between each use.
A heat sensor protects the machine by automatically cutting the power supply in case of overheating.
Maintenance:
- Clean the machine with a clean and dry cloth. Do not lubricate. Do not open or dismantle the machine.
- Avoid shock and dropping which will damage the machine; after a shock or a drop, check that the controls operate normally,
that the tool has no run out nor unusual vibration, that the covers have no play, are not cracked nor dented, and that the battery
is fastened properly.
Changing the chuck:
1) Fully open the chuck and unscrew the fastening screw located at its centre (caution: reversed unscrewing direction).
2) Position the speed selector to «low», the torque selector in the drilling position and the rotation direction reverser in the unscrew position.
3) According to your chuck model, insert and lock the appropriate disassembly wrench (A) or lock the sleeve firmly
(B). Lock the machine firmly and pull the trigger to unscrew the chuck.
1
For more information: call your FACOM distributor.
NU-CLP_1005
2
LOW
13
5 6
2
3
STOP
B
18/11/05, 9:06
STOP
A