LD Systems AM 8 Manual De Usuario página 8

24
23
25
26 28
27
23
SUM VOLUME MASTER 1 + 2
Encoder for setting the total volume of the line outputs Master 1 and Master 2 (dual function). If the display LED 1 lights up green (N°26), the
sum volume of the line output Master 1 can be adjusted as desired using the MASTER rotary encoder. If the display LED 2 lights up green
(N°27), the same applies to the line output Master 2. Turning it to the right increases the volume and turning it to the left reduces it.
Select the line output Master 1 or Master 2 for volume setting by first pressing the push-button of the MASTER rotary encoder and then holding
it down for approximately 2 seconds. Now, while the LED display of the currently selected line output from Master 1 (N°26) or Master 2 (N°27)
flashes red, select the other line output for adjusting the total volume using the MASTER rotary encoder. Confirm the selection by pressing
the push-button on the MASTER rotary encoder. By combining the two output channels Master 1 and 2 in a channel group (see CHANNEL
GROUPS), the volume of both channels can be set simultaneously using the MASTER rotary encoder.
24
LED DISPLAY MASTER
15-segment LED display for viewing the volume setting for the line outputs Master 1 or Master 2.
25
PUSH-BUTTON MASTER
Push-button to select the volume or the output level (Line / Mic) of the line outputs Master 1 and 2 (see point 23 and 28).
26
STATUS-LED MASTER 1
If the LED 1 display lights up green, the sum volume of the line output Master 1 can be adjusted as desired using the MASTER rotary
encoder (see also point 23).
27
STATUS-LED MASTER 2
If the LED 2 display lights up green, the sum volume of the line output Master 2 can be adjusted as desired using the MASTER rotary
encoder (see also point 23).
8