Combustion P - Carbel VISION Manual De Instrucciones De Uso Y Mantenimiento

The installation of the appliance must comply with all local regulations, including those that refer to national and
European standards.
Vision insert installation
Although the following describes an example installation to ensure good performance, it may not be ideal for your
circumstances. In any case, it is always better to have a professional do the installation. If you are determined to do
your own installation, consult a professional.
The on-site termination must be such that it allows the dilatation of the heater during its operation; the work
must never be supported on top, or against the sides of the device. Leave a minimum dilatation joint of 0.5 cm
at each side and at least 1cm at the top of the front.
3. FUNCTIONING
1
5
4
2
1- Fumes exhaust pipe Ø 150.
2- Optional. - Box with ventilator
to fan the convection air
6
through the chamber of the
heater.
3- Air inlet to the convection
chamber of the chimney, by
natural convection.
4- Entry of external air for
combustion.
5- Outlet of hot air from the
convection chamber of the
heater.
6- Optional outlet of hot air to
other rooms.
3
Dilatation joint,
at least 1 cm.
13