Maintenance; Warranty - Normfest WSK2000W Instrucciones De Uso

machine case must be carried out in an authorized ser-
vice centre for NORMFEST power tools.
RECOMMENDATIONS
When cutting, do not apply pressure, do not oscillate the
wheel. Work with moderate feed rate, suited to the mate-
rial to be machined.
The direction of cutting is very significant. The machine
must always be fed against the direction of wheel rota-
tion. Otherwise, danger exists for the wheel to be forced
uncontrolled out of the cut. (Fig. 6)
When cutting profiles or rectangular pipes it is best to
start with the smallest cross section.
When grinding do not apply pressure to the processed
surface by rearing down on the machine but move
the wheel regularly backwards and forwards. Special
wheels shall be used for processing non-ferrous met-
als. Best results when roughing can be achieved with the
wheel inclined at 300 to 400 to the processed surface
(Fig. 7).
Never use cutting wheels for roughing operations. Us-
age of wheels thicker than 10 mm is not recommended.

Maintenance

WARNING: Always ensure that the tool is
switched off and unplugged before attempting to per-
form inspection or maintenance.
BRUSH REPLACEMENT
This power tool is equipped with auto-stop brushes.
When the carbon brushes are worn out, the machine
switches itself off. In this case both brushes must be re-
placed simultaneously with genuine brushes at NORM-
FEST service centre for warranty and post-warranty
service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they are
properly tightened. Should any of the screws be loose,
retighten it immediately to avoid hazards.
If the replacement of the supply cord is necessary, this
has to be done by the manufacturer or his agent in order
to avoid a safety hazard.
CLEANING
For safe operation always keep the machine and its ven-
tilation slots clean.
Regularly check to see if any dust or foreign matter
has entered the ventilation slots and the grills around
the switches. Use a soft brush and/or air jet to remove
any accumulated dust. Wear safety glasses to protect
your eyes whilst cleaning.
Exterior plastic parts may be cleaned with a damp cloth
and mild detergent if necessary.
Original instructions
WARNING: Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
WARNING: Water must never come into con-
tact with the tool.
IMPORTANT! To assure product safety and reliability,
repairs, maintenance and adjustment should be per-
formed by certified service centres or other qualified
service organisations, always using genuine replace-
ment parts.

Warranty

The guarantee period for NORMFEST power tools is de-
termined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective NORMFEST power tools
will be recognized if the machine is sent back to the
dealer or is presented to the authorised warranty service
centre undismantled, in its initial condition.
Notes
Carefully read the entire Instruction Manual before using
this product.
The manufacturer reserves the right to make changes
and improvements to the products and to alter specifica-
tions without prior notice.
Specifications may differ from country to country.
19
EN