Dynsys System - Fantek FT-6860 Manual De Instrucciones

DYNSYS SYSTEM

The Dynsys system is an optional solution to control the maximum load in our tower lifters.
The Dynsys limits the máximum load avoiding to lift a load bigger than the máximum load. The limitation is
do it for use as a machine system. For more information about the máximum load, check the load table.
In case of lift a load bigger than the máximum of the tower, the Dynsys detects the incriase of load and stops
the elevation. In that case the load only can go down.
In case of limitation, the Dynsys advise with noise.
The Dynsys Works like a preventive maintenance. If the tower works with problems like damaged internals,
bad state of steel wire, the dynsys limits the maximum load decreasing it till the tower works fine. If this
happens, please contact with technical department or your local distributor.
The system allows to dismantle the lever. You can block the tower removing the lever. This is a form to
ensure that nobody alien to the show can move the tower up or down. You only need to remove the Allen
screws.
Figure 91
18
USER MANUAL FOR P.A. TOWERS